Size of Wind Turbines
2008-08-27 @ 16:05 EEST
Views: 399
Power Output Increases with the Swept Rotor Area
When a farmer tells you how much land he is farming, he will usually state an area in terms of hectares or acres. With a wind turbine it is much the same story, though doing wind farming we farm a vertical area instead of a horizontal one.
The area of the disc covered by the rotor, (and wind speeds, of course), determines how much energy we can harvest in a year.
The picture gives you an idea of the normal rotor sizes of wind turbines: A typical turbine with a 600 kW electrical generator will typically have a rotor diameter of some 44 metres (144 ft.). If you double the rotor diameter, you get an area which is four times larger (two squared). This means that you also get four times as much power output from the rotor.
Rotor diameters may vary somewhat from the figures given above, because many manufacturers optimise their machines to local wind conditions: A larger generator, of course, requires more power (i.e. strong winds) to turn at all. So if you install a wind turbine in a low wind area you will actually maximise annual output by using a fairly smallgenerator for a given rotor size (or a larger rotor size for a given generator) For a 600 kW machine rotor diameters may vary from 39 to 48 m (128 to 157 ft.) The reason why you may get more output from a relatively smaller generator in a low wind area is that the turbine will be running more hours during the year.
Reasons for Choosing Smaller Turbines
- The local electrical grid may be too weak to handle the electricity output from a large machine. This may be the case in remote parts of the electrical grid with low population density and little electricity consumption in the area.
- There is less fluctuation in the electricity output from a wind park consisting of a number of smaller machines, since wind fluctuations occur randomly, and therefore tend to cancel out. Again, smaller machines may be an advantage in a weak electrical grid.
- The cost of using large cranes, and building a road strong enough to carry the turbine components may make smaller machines more economic in some areas.
- Several smaller machines spread the risk in case of temporary machine failure, e.g. due to lightning strikes.
- aesthetical landscape considerations may sometimes dictate the use of smaller machines. Large machines, however, will usually have a much lower rotational speed, which means that one large machine really does not attract as much attention as many small, fast moving rotors. (See the section on wind turbines in the landscape ).
